|
The Roman
administration, however, needed a better network of roads to
connect its new towns and army posts and to speed the flow of both
trade goods and troops. In building their network of roads the
Romans mostly ignored the Celtic paths, partly because the Roman
towns and forts were built on new sites away from the Celtic
settlements. Click
here to view the Roman Road network
The most
vital priority was the movement of troops and supplies from the
channel ports of Richborough, Dover, and Lympne to the military
centres at London, Colchester, and the front-line legionary forts.
The first frontier was set up along a road extending from Exeter
to Lincoln, running through Bath, Gloucester, and Leicester. This
was known as the Fosse Way, the first
great Roman road in Britain. The Fosse Way has been largely
adapted by modern highways.
The next
military push established a new frontier between Lincoln and York,
Wroxeter and Chester, and Gloucester and Caerleon. After these
"front-line" roads had been established. The Romans
turned their attention to expanding the network of minor roads
within their new possessions, to better aid the flow of trade.
By 82AD the
Romans had pushed north as far as a line between the Clyde and the
Firth of Forth. During this campaign alone the army built over 60
forts and over 1200 miles of roads. The
imperial posting service, used by Roman officials, maintained inns
and relays of horses at intervals of 30 to 50 kilometres along the
roads.
The
minor roads (sometimes called "economic roads") were
also built by the Roman army to link economic centres, such as the
Mendip lead mines and the Nene potteries, with administrative
capitals like Silchester, and the coastal ports. At a best guess
there were between 8000-10,000 miles of roads constructed during
the first hundred years of Roman occupation. There
was a third level of roads at the local level, connecting villas,
temples, farms, and villages to larger roads and market towns. The
full extent of this road building is apparent when you consider
that according estimates by historians, no village or farm was
more than 7 miles from a purpose-built road!
It is a
fallacy to think that Roman roads are always straight. The Roman
engineers were no fools - if there was a natural obstacle in the
way, the road naturally deviated to go around it. The Romans had
yet to invent front axle steering, so sharp corners where avoided.
That said,
for the most part Roman roads were laid out in straight lines
between sighting landmarks. Small hills were cut through, and wet
ground covered by causeways, or timber embankments.
So,
how did the Romans build these famous roads of theirs? The
roads were literally highways, raised up on a cambered bank of
material dug from roadside ditches. In general there were 3
layers. The first layer of large stones was covered by a second
layer of smaller stones, then a top layer of gravel or small
stones. Each layer varied in depth from 2-12 inches.

Cross-section
of a Roman road showing the layering technique and outer ditches
|